Product Details
This Jack's Magic Multipack Includes: 2 Boxes
Jack's Magic Stain IDentification Kit - 2 Pack
The Stain ID Kit is the first step in performing a successful Jack's Magic stain removal. The Stain ID Kit is designed to take the guesswork out of removing swimming pool stains.One of the four simple topical tests will identify what bests removes a swimming pool stain, saving both time and money. Please note that the water should be at least 65-70 degrees in order to insure accurate testing results. Jack's Magic Products, Inc., the pool and spa industry's leader in identifying, preventing and removing stains and discoloration, has built a reputation for innovative quality products and programs that deliver results. By treating stain issues with the pool water left in the pool, it is estimated that Jack's Magic products save over 200 million gallons of pool water annually that would otherwise be lost if a pool was drained and acid washed. Jack's Magic is one of the most widely known and respected brands, and is marketed and distributed nationally and internationally. Committed to the highest levels of customer satisfaction, Jack's Magic supports its brand, products, programs, and customers through training, education, and support.
Frequently Asked Questions:
1. How important is it to have the chemistry within the parameters when doing the stain ID?
It is very important! Most unsuccessful IDs are a result of not properly following the product's instructions.
2. My stain is in the deep end of the pool or on the wall; how do I do the ID?
There are a few different ways to address this issue. If you have adjusted your water balance according to the instructions and have the pump turned off, wait for the water to stop moving. Then you can sprinkle a small amount of each packet into the water. As the product dissolves it becomes a solution that is heavier than the water. This solution will sink to the bottom and begin to react with the stain. This process should be repeated with each product. Patience is the key to using this method as it takes time for the solution to sink and react. Another method is to put a small amount of material in a piece of hosiery, attach it to the vacuum pole and hold it directly over the stained area. As before, this would need to be repeated with each product in the kit.
